Issue with EQ. – Page 2 – Tracktion Forum

I’ll have to look it up again – but I had used one of the MIDI toolboxes to convert pitch bend to mod wheel (I had a cheap Casio that only had pitch bend). I think it was MIDIConverter3 from the pizmidi collection, which also allows you to scale (specify input range to output range, which I had to do as pitch went negative; I only converted positive values to the range expected for MOD wheel). Nice simple tools, really small.

From the docs… This is just the key bits on output.

PS – the collection has things like velocity scaling, note filtering, a simple “strummer” to delay notes by different amounts, range filters; about 30 little “I didn’t know you could do that…” .VST tools.

midiConverter3

Change and convert between CC, Channel Pressure, Poly Aftertouch, Program Change, Pitch Bend, NRPN/RPN, Note On/Off, and other messages in various ways. Pitch Bend and (N)RPN conversions will use the full 14-bit values when possible.

Output Type – Options:
Discard – No conversion, just block the input message.
CC – Mapped value will be used as the value of a CC message set by Out Param 1, optionally
(set by Out Param 2) with smoothing.
14-bit CC – Mapped value will be used as the value of a 14-bit CC message pair set by Out
Param 1, optionally (set by Out Param 2) with smoothing.
Program Change
Channel Pressure
Poly Aftertouch – Mapped value will be used as the value of a polyphonic aftertouch message
with note number set by Out 1.
Pitch Bend – Mapped value will be used as the value of a pitch bend message, optionally (set
by Out Param 1) with smoothing.
Pitch Bend (LSB) – Mapped value will be used as the LSB of a pitch bend message with MSB set
by Out Param 1.