Numerical investigation of wrapped-face back-to-back reinforced soil walls: wall separation and the mobilized earth pressure
Back-to-back reinforced soil walls (RSWs) are widely used for bridge approaches and narrow embankments, but the available numerical evidence derives mostly from rigid or modular facing systems. Unlike rigid facing, a geosynthetic wrap provides negligible flexural rigidity, so lateral earth pressure is resisted only by soil–reinforcement interaction. Plane-strain finite element analyses simulate the staged construction of 6 m high wrapped-face back-to-back RSWs, evaluating wall separation, reinforcement continuity, vertical spacing, foundation stiffness, reinforcement creep and constitutive soil model. The largest change in response occurs when the two reinforced zones lose contact, rather than at the boundary between interacting and independent walls defined in design guidance. Separation increases displacements and tensile loads and lowers the factor of safety. Reinforcement continuity mainly reduces facing deformation, whereas vertical spacing controls both deformation and stability. Softer foundations reduce facing displacement while lowering the factor of safety, so facing displacement alone is an unreliable performance indicator. Over the design life, reinforcement creep increases facing displacement by about 26–30% but relaxes tensile loads. The mobilized earth pressure remains close to the at-rest state with the Hardening Soil model and vertical spacings up to 0.4 m, including after creep, but close to the active state with Mohr–Coulomb.
Read more here: Source link
