Modulating multiple destinations with an offset LFO – Bitwig Forum

Hi there.
I am trying to modulate several pan knobs (or any bipolar knobs for that matter) with a single LFO. I would like for each knob to start at a different phase in the wave of said LFO. Specifically, I would like 12 knobs spread at 30 degree increments. I currently have one sine LFO outputting to 12 modulators outs that each map to a knob. I would think that there is a module that I can drop in between the LFO and each mod out that I could set to offset by a certain number of degrees…but I can’t seem to find it. I can put a delay in there which gives me a similar effect, but it doesn’t give me the level of control that I’m looking for.

In the attached picture I’m just looking to put something where the Delay and Hold modules are that will allow me to offset the location of where the mod outs are in the phase of the wave, by degrees.

If there is a better overall way to do this, I’m all ears.

Thanks.