Good, low latency saturating brickwall for the master bus? – Effects Forum

I have some reservations about the general plan here to mix into a clipper then change the clipper. Saturate is not a normal waveshaper and will be hard to “match”! Still, looking for a low-latency soft clipper is a reasonable ask…

Perhaps El Juan with input saturation enabled?

apShaper has a low-latency mode; I think this still uses ADAA so should be cleaner than most other low-latency clippers?

If you are running at 96k there may be enough headroom to use one of the many airwindows clippers/waveshapers that doesn’t oversample.