Anyone with a Behringer Neutron that can check something for me? (in: Hardware (Instrument…)

By: JO512
8 Feb 03:32

I have a Behringer Neutron that had a couple of scratchy pots, the filter cutoff and the drive pots. I replaced them with new Alpha pots. I now notice some noise in the oscillators that I am not sure if was there previously. I patched directly from the OSC MIX to ATT 1 (attenuator 1) and directly out to my audio interface input to get as clean an oscillator signal as possible.

I have attached an audio file sweeping the sine wave from OSC1 and then switching to the saw and sweeping that a bit. …

Go to this post

Go to first unread post in this topic