Remix – Stem Separation – Acon Digital Forum

stian wrote:

Tue Sep 28, 2021 9:46 am

nivedhya@hotmail.com wrote:

Sun Sep 26, 2021 4:28 pm


In Remix Window – Stems Separation there is Sensitivity Option given – Default at 0 & varies from -100 to +100.

Where & for What output we have to use this & how?

I tried but unable to notice what is happening?

This changes the sensitivity (or the relative likelihood of detection) for each stem type. So if you for example increase the sensitivity for drums above 0%, there will be more signal components detected as drums.

Best,
Stian

I couldn’t get you correctly. I mean, you have said more drum signals will be detected. How is ‘more’ detection possible than what is present in the mix?

Could you throw more light on this? I mean the same example you said I take, in drum separation if I set 20% plus what will happen,for 50% like so 100% what will be the variation or where should I limit it?

Read more here: Source link