Setup BCD to boot PE from RAM?

I’m trying to configure a running Windows 10 system to boot Windows PE from RAM but so far no luck.

I’ve read the documentation but my understanding of the boot parameters are a bit lacking.

This is what I have right now:

 Windows Boot Loader
 identifier              {a84dfb42-1b85-11ec-b7bc-b42e99f68438}
 device                  ramdisk=[C:]sourcesboot.wim,{ramdiskoptions}
 path                    windowssystem32winload.efi
 description             Windows PE
 osdevice                ramdisk=[C:]sourcesboot.wim,{ramdiskoptions}
 systemroot              windows
 nx                      OptIn
 detecthal               Yes
 winpe                   Yes

I created this boot option with the following commands:

 bcdedit -create /d "Windows PE" -application osloader
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} device ramdisk=[C:]sourcesboot.wim,{ramdiskoptions}
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} path windowssystem32winload.efi
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} osdevice ramdisk=[C:]sourcesboot.wim,{ramdiskoptions}
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} systemroot windows
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} winpe yes
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} nx optin
 bcdedit /set {a84dfb42-1b85-11ec-b7bc-b42e99f68438} detecthal yes

Then I set a one-time boot:

 bcdedit /bootsequence {a84dfb42-1b85-11ec-b7bc-b42e99f68438}

Finally, to test and reboot:

 shutdown /r /f /t 0

Upon restarting, when the system boots I hear the fans start but then they stop following a few seconds of silence.
The system then starts again with the fans at full speed it sounds like but nothing is displayed on the monitor.
I then have to power it off 1 or 2 times to let the normal boot procedure kick in so I can get back into Windows.

I created the Windows PE files from the Deployment and Imaging Tools Environment from the Windows ADK and WinPE add-on.
The boot.wim is a copy from c:winpe_amd64mediasources

Also, I noticed I don’t have any .sdi file specified.

What does the .sdi do and what is it for?

Also, It just hit me, do I need to make any changes to the BCD store located in the boot.wim?

Or is configuring the currently running operativ systems BCD enough?

To my understanding the above settings should:

Please correct me if I’m wrong or missing anything.

EDIT: After checking the {ramdiskoptions} with:

 bcdedit /enum {ramdiskoptions}

I noticed it was empty:

 Setup Ramdisk Options
 identifier              {ramdiskoptions}

So I added some more information after some research:

 bcdedit /set {ramdiskoptions} ramdisksdidevice partition=C:
 bcdedit /set {ramdiskoptions} ramdisksdipath winpe_amd64mediaBootboot.sdi

Using this configuration gives me the boot error:

Status: 0xc000000f “A required device isn’t connected or can’t be accessed.”

Read more here: Source link