PS20 Patch Panel Tutorial – Page 2 – Cherry Audio Forum

ghostwhistler wrote:

Sun May 16, 2021 9:02 pm

Koshdukai wrote:

Sun May 16, 2021 8:35 pm

ghostwhistler wrote:

Sun May 16, 2021 8:29 pm

Koshdukai wrote:

Sun May 16, 2021 7:41 pm


See the Red and Blue/Cyan cables ? That’s modulating the HP and LP filters. Just set the amount you need in the knobs to the left (2 of the 4 with the green line I added below the label text)

Thanks but I don’t see the point of the square wave modulation connection to the clock as it does absolutely nothing

how do you clock (trigger) the S&H ?

It does it regardless. The effect comes through the same with or without that patch

You’re right, I didn’t realize that CA pre-wired PS-20’s MG SQR to S&H’s Clock, so that wire isn’t needed. I just did it initially to make it as close to what Mark was explaining on the MS-20.

PS-20 MG SQR prewired to S&H CLK.JPG

MS-20 MG SQR not prewired to S&H CLK.JPG

You do not have the required permissions to view the files attached to this post.

Read more here: Source link